I bet that in nort Sweden living guys do need some grip to they tires, and there is two way to get it.
One is kold kutters, easy to install but they weight quit a lot.
Second bit more job to do, is metal sheet screws, amazing grip and cheap to do.
Here is how i did mine.
My tires were hostile mxt, but you can use also hostile mx and minipin tires and proline bowtie tires, well, these i have used.
First you need to drill hole on the tire, 4mm drill is good.

And DO drill the hole center of the knob..
Turn the tire up side donwn ,and start to drill the metal sheet screws in to the tire, with those holes you did drilled just before.

Be gently, low rpms.
http://www.youtube.com/watch?v=eu9e4p49 ... ture=g-upl
I used 13mm metal sheet screws.




In front in the middle i used only one and second know gets the screw.
On the rear, i used all the knobs, so there is in every know this very sharp screw.

And do remember, on the front tires do it as zigzag
Forget those koldkutters, this is how it should be done, and it is cheaper too..



