Remove bell and access clutch in about 1 minute without tearing the whole model apart
Remove bell and access clutch in about 1 minute
15mm shaft.
12 mm hex.
Bearings spaced out 2mm to 20mm up from 18mm to add more stability to the bell shaft.
Rear and bottom of cover are open to allow dirt to escape.
18t pinion 60 days away
![Image](http://img.photobucket.com/albums/v342/Vertigoperformance/61680Mediaphotocombination.jpg)
![Image](http://img.photobucket.com/albums/v342/Vertigoperformance/61680Sideviewinstalled.jpg)
http://www.vertigoperformance.com/~vert ... cts_id=362